Research on Drilling Process of Deep Hole Trepanning for Titanium Alloy(TC4)

Zhanfeng Liu, Wencui Zheng, Hanlin Zhu

Abstract


According to the cutting performance of titanium alloy, combined with material processing problems, this dissertation puts forward a set of suitable processing technology for titanium alloy materials through chip performance analysis and experimental analysis. The test results showed that when the speed n is 110r / min, feed rate is 0.2mm / r, and the cutting fluid flow is 250L / min, the processing process and the chip removal are relatively smooth.

Keywords


Trepanning Deep Hole Drilling Titanium Alloy


DOI
10.12783/dtcse/icmsie2017/18806

Refbacks

  • There are currently no refbacks.